|
|
|
|
462 heads, 9" rear, .....
|
| Selected Ad |
| Category: |
Performance Parts For Sale |
| Title: |
462 heads, 9" rear, ..... |
| Ad
Number: |
15250 |
| Date Posted: |
12/6/2005 |
| Contact: |
Colin Robinson
Conway, AR
|
Description
9" housing 57" with heavy duty axles set up for metric chassis no chunk $250
Double hump heads casting #8890462 66-67...302/327/350..,no accessory holes, 64cc chamber 2.02/ 1.60 (stainless exhaust) virgin heads I had them magnafluxed and they checked ok. They are currently assembled. $250
78 Firebird Esprit Clear title good body with just a few small rust spots. Dash and front seats are all the interior it has. No motor or trans all glass but pass door. The rear end is a 10 bolt 273 gears But the carrier will need rebuilt or replaced. The pass axle is also broke but the wheel will stay on good enough to get it on a trailer. $500
Pure Stock Camaro needs body and cage has 10 bolt .411 rear welded spider gears, seat, fuel cell, quick steer, 15x8 wheels (I think 6 of them 5 on 5) Good ps pump with remote resevor. 750 or will part out.
383 SBC forged flattop pistons 11.5-12.5 compression Comp cams cam and lifters http://www.compcams.com/Technical/Search/CamDetails.asp?PartNumber=12-240-4 True double roller chain, two peice timing cover.
Moroso high volume/ high pressure oil pump, pickup, and oil pan. Scoggin dickey Vortech heads with upgraded valve springs (good up to .525 lift) screw in studs and guide plates. Elgin push rods. Edelbrock performer intake. Desktop dyno claimes 400HP 425 lbft. $3000
Will trade all for a race ready Econimy mod or part for a roller. Also interested in a Mig welder, air compresser, 373 or 410 gears and posi unit for 10 bolt 7.5", same ratio and chunk for 9" I'm sure I could go on but you probably get the point. |
|
|
|
|
|
|
|
|
|